About this task
The following image indicates the location of the power-button board with USB and provides a visual representation of the
removal procedure.
Figure 48. Removing the power-button board with USB
Steps
1. Remove the five screws (M3x4.5) that secure the left-stand hinge to the display-assembly base.
2. Lift the left-stand hinge off the display-assembly base.
3. Remove the screw (M3x5) that secures the power-button board to the display-assembly base.
4. Peel the tape that secures the power-button board cable to the power-button board.
5. Gently lift the power-button board from the tabs on the display-assembly base.
6. Open the latch and disconnect the power-button board cable from its connector (TYPE-C) on the power-button board.
7. Lift the power-button board off the display-assembly base.
Installing the power-button board with USB
CAUTION:
The information in this section is intended for authorized service technicians only.
Removing and installing Field Replaceable Units (FRUs)
73