Wire Connector
Bolt
Washer
Fuel Tank
(13) Oil Separator Filter Replacement
Replace
① Remove the cover, and
remove the O-ring and oil
separator filter.
② Assemble a new O-ring to
the cover and spread a thin
layer of oil on the O-ring.
③ Assemble a new oil
separator filter and tighten
the cover by hand.
< Note >
Replace with a new O-ring each time the oil separator filter
is replaced.
Oil separator filter part no. (with O-ring):1J419-05811 (Kubota part no.)
Wire Connector
Fuel Line (Inlet Side)
Fuel Line (Return Side)
Every 1000 hours
Oil Separator
36
Lifting Hook
Bolt
Washer
Inlet Port
Return Port
Spill Containment
Loosen
Tighten
Cover
O-ring
Oil Separator
Filter
Oil Separator