Shindaiwa DG50MKM-P Owner's And Operator's Manual page 38

Spill Containment Separate/ Reassemble
① Turn the 3way fuel valve lever to the "B" side.
② Remove the wiring connector.
③ Remove the fuel hoses (supply and return sides).
④ Remove the four spill containment fixing bolts
(M12, 8 pieces).
< Note >
 When removing the fuel hoses, hold the union joint fixed
using a spanner or similar tool.
 Prepare a container to receive the fuel remaining in the
fuel piping that will flow out of the removed fuel piping.
⑤ Lift the generator, separate the spill containment and set the generator on a flat surface.
⑥ After cleaning and inspecting the inside of the spill containment, reassemble the spill
container with this generator by performing the above procedures in the reverse order.
⑦ Reassemble the fuel piping and wiring connector to their original positions.
⑧ Turn the 3way fuel valve lever to the "A" side.
< Note >
 After reassembling, bleed air from the fuel system.
(Refer to section "9-2. Procedures during Operation".)
 After reassembling, check that there is no fuel leakage.
Spill Containment Cleaning/Inspection
① Use a high-pressure cleaner or similar equipment to
clean the inside of the spill containment.
② After cleaning, allow water to accumulate and check that
the spill containment has no internal leakage.
③ Remove the drain plug (R1") to drain the cleaning water.
④ Check that there no rust has developed inside of the spill containment. If rust has
developed, remove the rust and clean again.
⑤ After the procedures have been completed, apply sealant coating to the plug (R1") or
wrap it in seal tape.
< Note >
 If the fluid drained when cleaning the spill containment contains oil or grease, dispose of
it according to the related laws and regulations.
 If the spill containment has a leak, contact the authorized distributor where the generator
was purchased.
Inlet port Return port
Position B
35
Inlet port Return port
Position A
Drain Plug (R1")