Shindaiwa DG50MKM-P Owner's And Operator's Manual page 32

(1) Engine Oil Replacement
First Time
Thereafter
① Remove the oil filler cap.
② After removing the oil drain plug and packing(a rubber seal is attached),open the oil
drain faucet and drain the engine oil.
③ After the oil has been drained,close the oil drain faucet and reinsert the oil drain plug
with new packing(a rubber seal is attached).
④ Add oil through the oil filler until it is at the maximum level while checking the fuel level
using the oil level indicator.
⑤ Attach the oil filler cap.
< Note >
 Refer to section "8-1. Checking Engine Oil" for engine oil replacement amounts and
types.
 Replace the packing of the oil drain plug with new packing each time the oil is replaced.
 Packing part no. : V106-000190
 After reinserting the oil drain plug and shortly after starting the engine, be sure to always
check that there is no oil leakage.
(2) Replacing the Oil Filter
First Time
Thereafter
① Drain the engine oil. (Refer to section "(1) Engine Oil
Replacement".)
② Remove the oil filter using a filter wrench.
③ Spread a thin layer of oil on a new oil filter gasket.
④ Thread the oil filter by hand, and turn by hand (do not use a filter wrench) from when
the gasket contacts the seal surface until it is securely tightened.
⑤ Add engine oil to the generator.
⑥ Shortly after starting the engine, always be sure to check that there is no oil leaking
from the seal surface.
< Note >
 Request the authorized distributor where the generator was purchased to perform this
procedure if you do not have a filter wrench.
 Oil filter part no. : 1C020-32434 (Kubota part no.)
50 hours
Every 500 hours
Oil Level
Indicator
Oil Filler Cap
50 hours
Every 500 hours
Oil Drain plug
and Packing
29
Open
Close
Oil Drain Faucet
Oil Drain Plug
Gasket