Run Inventory; Set Data Compression - Quantum SuperLoader 3 User Manual

Chapter 4 SuperLoader Operation

Run Inventory

Run Inventory

Set Data Compression

98
Flex I/O Status:
Version:
The SuperLoader automatically runs an inventory whenever you power
it back on or insert a magazine. An inventory checks each magazine slot,
the drive, the picker, and the mailslot to determine if a cartridge is
present. If so, it also reads the bar code label, if possible. If you need to
run an inventory in addition to this, you can do so manually.
No bar code labels can be read if there is a tape in the picker.
Note:
To Perform an Inventory Manually:
1 On the main menu, scroll to
2 On the Commands submenu, scroll to
SuperLoader scans the bar codes of all the cartridges present.
For the SuperLoader DLT, you can set the SuperLoader to write data to
the tape in its native (uncompressed) format or to compress it.
This command is not available for the SuperLoader LTO.
Note:
SuperLoader User's Guide
Indicates the type of Flex I/O card that is installed
Indicates the current version of the Flex I/O
firmware.
Commands
Inventory
, then press .
Enter
, then press
Enter
4
4
. The
4