Run Drive Diagnostics
Install Device Drivers
Configure the Tape Drive to a Server/Host
Quantum LTO-9 HH SAS User's Guide
characters. Each segmented character represents a test performed
during the POST. When the POST finishes, the SCD momentarily
lights all segmented characters and then goes blank.
Run the Standalone Diagnostic (see
Diagnostics
on page 49).
A device driver is firmware that enables the tape drive to interact with a
variety of servers. See
instructions on downloading the latest device drivers.
If you intend to use the tape drive with a commercial software
application, refer to that application's installation instructions to install
the device driver and configure the tape drive.
1 Power-on the unit.
2 To configure the tape drive, refer to the documentation for your
server/host and application software.
Function Code 1: Run Drive
Supported Device Drivers
Chapter 3: Installation
Run Drive Diagnostics
on page 20 for
29