Table of Contents
Advertisement
Run Drive Diagnostics
Install Device Drivers
Quantum LTO-5 HH SAS Model C User's Guide
during the POST. When the POST finishes, the SCD momentarily
lights all segmented characters and then goes blank.
Run the Standalone Diagnostic (see
Diagnostics
on page 46).
Note: Optionally, you can use the xTalk tool to verify host to drive
communications and to run a device test that will send data
across the host interface. For more information on xTalk, visit
www.quantum.com/serviceandsupport.
A device driver is firmware that enables the tape drive to interact with a
variety of servers. Refer to
instructions on downloading the latest device drivers.
If you intend to use the tape drive with a commercial software
application, refer to that application's installation instructions to install
the device driver and configure the tape drive.
Function Code 1: Run Drive
Supported device drivers
Chapter 3: Installation
Run Drive Diagnostics
on page 18 for
27
Advertisement
Table of Contents
