Touchscreen Icons - Johnson Controls TEC3023-14-000 Installation Manual

Touchscreen icons

The following table describes the touchscreen icons on the home screen. Press and release a touchscreen icon to activate
the TEC. Additional touchscreen icons appear based on the menu, and those icons are also described in the table.
Table 6: Touchscreen icons
Icon Icon name
Menu
Alarm
Unit Power
On
Standby
Humidity
On
Standby
Degree
On
Standby
Network
Communication (for
Networked Models)
No Signal
Radio Signal (for
Wireless Models)
No Signal
Low Signal
Medium Signal
High Signal
Arrow Up
Arrow Down
Arrow Up
Arrow Down
10 TEC3000 Series Proportional Fan Coil Thermostats Installation Guide
Description
Displays the configuration screens where various settings may be
adjusted.
Indicates that the thermostat controller has triggered an alarm.
Powers the thermostat controller on or off.
Note:
• This icon disables all equipment control but does not
physically power down the unit.
• On the modern home screen, if the Unit Power icon is in
standby mode, the temperature and humidity also display in
standby mode to indicate that control off or standby mode is
active.
Indicates the humidity reading.
Indicates that the unit is set to degrees.
Indicates that the thermostat controller detected a supervisory
controller and both are online.
Indicates that the thermostat controller did not detect a supervisory
controller.
Indicates the strength of the radio signal.
Increases or decreases the cooling value on the home screen.
Increases or decreases the heating value on the home screen.