Ieee Standards; Agency Compliance; Usa Federal Communications Commission Statement - Dell PowerSwitch N3200-ON Series Installation Manual

● Internal PSU only: Internal PSU power output - maximum system power consumption
● Internal PSU + one external power adapter: Internal PSU power output + one external power adapter power output -
maximum system power consumption
● Internal PSU + two external power adapters: Internal PSU power output + two external power adapters power output -
maximum system power consumption

IEEE standards

The N3200-ON/E3200-ON Series switch complies with the following IEEE standards.
● 802.3ab
● 802.1ax (Layer 2)
● 802.1d, 802.1w, 802.1s, 802.1x (Mgmt/Security), 802.3x (Layer 2)
● 802.3
● 802.3ba (40 GbE and 100 GbE)
● 802.3bt
● 802.3at
● 802.3az
● 802.1v
● 1613
● 802.1p, 1q
● 802.1s
● 802.3u, 802.3bz

Agency compliance

The N3200-ON/E3200-ON Series switch is designed to comply with the following safety and agency requirements:

USA Federal Communications Commission statement

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC
rules. These limits are designated to provide reasonable protection against harmful interference when the equipment is operated
in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy. If it is not installed and
used in accordance to the instructions, it may cause harmful interference to radio communications. Operation of this equipment
in a residential area is likely to cause harmful interference, in which case users will be required to take whatever measures
necessary to correct the interference at their own expense.
Properly shielded and grounded cables and connectors must be used in order to meet FCC emission limits. Dell is not responsible
for any radio or television interference caused by using other than recommended cables and connectors or by unauthorized
changes or modifications in the equipment. Unauthorized changes or modification could void the user's authority to operate the
equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
Figure 6. Canadian Department of Communication Statement
84 Specifications