Ieee Standards; Agency Compliance; Usa Federal Communications Commission (Fcc) Statement - Dell S6010-ON Installation Manual

Parameter
Maximum Power Consumption
Typical Power Consumption
Table 6. DC power requirements
Parameter
Minimum/Maximum Input Voltage Range
Input Power at Full Load
Input Current at Full Load
Start up VDC
Start off VDC

IEEE standards

The S6010-ON complies with the following IEEE standards:
• 802.3ab Gigabit Ethernet (1000BASE-T)
• 802.3ae 10 Gigabit Ethernet (10GBASE-X)
• 802.3ba 40 Gigabit Ethernet (40GBase-SR4, 40GBase-CR4) on optical ports
• 802.3u Fast Ethernet (100BASE-TX)
• 802.3z Gigabit Ethernet (1000BASE-X)

Agency Compliance

The S6010-ON is designed to comply with the following safety and agency requirements.

USA Federal Communications Commission (FCC) Statement

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules.
These limits are designated to provide reasonable protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy. If it is not installed and used in accordance to the
instructions, it may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause
harmful interference, in which case users will be required to take whatever measures necessary to correct the interference at their own
expense.
Properly shielded and grounded cables and connectors must be used in order to meet FCC emission limits. Dell Networking is not
responsible for any radio or television interference caused by using other than recommended cables and connectors or by unauthorized
changes or modifications in the equipment. Unauthorized changes or modification could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
40 Specifications
Specifications
2.05A @ 411W/200Vac
411W = 1402 BTU/hr
398W
Specifications
−40.5V /−48V/ −60V
−40.5V/970W −48V/930W −60V/ 950W, without fan
−40.5V/980W −48V/940W −60V/ 960W, with fan
−40.5V/23.8A −48V/19.0A −60V/ 15.6A, without fan
−40.5V/24A −48V/19.2A −60V/ 16.0A, with fan
39.0+/−1.5V
37.5+/−1.5V