Optics Installation; Optics Removal - Dell PowerSwitch N3200-ON Series Installation Manual

Figure 3. Four-post threaded round-hole installation
2. Attach the front and back flanges for each rail to the post flanges with two user-supplied screws at each end.

Optics installation

The N3200-ON/E3200-ON Series has SFP+, SFP28, and QSFP28 optical ports.
For a list of supported optics, see the specification sheets at
CAUTION: ESD damage can occur if components are mishandled. Always wear an ESD-preventive wrist or heel
ground strap when handling the N3200-ON/E3200-ON Series switch and components.
WARNING: When working with optical fibers, follow all warning labels and always wear eye protection. Never
look directly into the end of a terminated or unterminated fiber or connector as it may cause eye damage.
1. Position the optic to enter the port correctly.
The optic has a key that prevents it from being inserted incorrectly.
2. Insert the optic into the port until it gently snaps into place.
NOTE: When you cable the ports, be sure not to interfere with the airflow from the small vent holes above and below
the ports.

Optics removal

Remove an optic by pushing the tab on the optic and sliding the optic from the port.
When removing optics with direct attach cables (DACs) from the port, pull the release tab firmly and steadily. Before pulling the
release tab, you must gently push the optic into the port to ensure that it is seated properly. Do not jerk or tug repeatedly on
the tab.
42 N3200-ON/E3200-ON Series switch installation
www.dell.com/support or contact your Dell Sales representative.