Mercedes-Benz E CLASS 2020 Operator's Manual page 406

404 Wheels and tires
The tire pressures are already being moni‐
tored.
Compare the tire pressure with the recom‐
#
mended tire pressure for the current operat‐
ing condition ( page 400). Observe the
/
notes on tire temperature ( page 399).
/
% The values displayed in the multifunction dis‐
play may deviate from those of the tire pres‐
sure gauge as they refer to sea level. At high
altitudes, the tire pressure value indicated by
a pressure gauge are higher than those
shown by the on-board computer. In this
case, do not reduce the tire pressure.
Make sure to observe the following further rela‐
ted subject:
Notes on tire pressure ( page 399)
/
R
Restarting the tire pressure monitoring sys‐
tem
Requirements:
The recommended tire pressure is correctly
R
set for the respective operating status on
each of the four wheels ( page 399).
/
Restart the tire pressure monitoring system in
the following situations:
The tire pressure has changed.
R
The wheels or tires have been changed or
R
newly installed.
On-board computer:
Service Tires
4 5
Swipe downwards on Touch Control on the
#
left-hand side of the steering wheel.
The Use Current Pressures as New Refer-
ence Values? message is shown in the multi‐
function display.
To begin restart, press Touch Control on the
#
left-hand side of the steering wheel.
The Tire Press. Monitor Restarted
shown in the multifunction display.
Current warning messages are deleted and
the yellow h warning lamp goes out.
After you have been driving for a few
minutes, the system checks whether the cur‐
rent tire pressures are within the specified
range. The current tire pressures are then
accepted as reference values and monitored.
Make sure to observe the following further rela‐
ted subject:
Notes on tire pressure (
R
message is
page 399)
/