Responsibility Matrix - Fuji Xerox C60 Instruction Manual

*Where a dedicated supply is not available, it is the customer's responsibility to provide the equivalent, and where the
equivalent is not available, Fuji Xerox will not be held responsible for any damage that may occur.
Fuji Xerox will not be held responsible for any damage that may occur as a result of lightning strikes, power surges, etc.
Fuji Xerox recommends protecting the Fiery Print Server from surges or spikes in electrical power that can damage the
server and result in extended downtime. In areas that tend to experience brownouts or blackouts with more frequency,
installation of an Uninterruptible Power Supply (UPS) is suggested. This protection is the responsibility of the customer.
It is not recommended to have a UPS with software installed. The additional introduction of the software is untested and
not verified by Fuji Xerox.
Surge protectors & UPS's are provided by the Customer.
Power Consumption / Heat Emission / Noise Emission
Color C60 & C70 Printer
Power Consumption
Heat emission
Noise emission
Sound pressure level according to ISO7779
dB (A)-weighted sound pressure level (bystander positions)

Responsibility Matrix

The following table summarises customer and Fuji Xerox responsibilities relating to the product:
Ensure adequate space and power to install device
Confirm and maintain network integrity
Unpack device components
Connect all system components and install device hardware
Install client software / device drivers on PC/workstations
Configure device to connect to the network
Acquire and install client workstation network hardware and software
Initial operator training
Order and install specified Customer Replaceable Units (CRUs) according to
machine instructions (refer to 'Supplies' section later in this document)
Order and install staple and dry ink cartridges according to machine instructions
Remove, repair and re-install any failed components
Provide Helpline support (Customer Care Centre)
Provide spare parts
Provide service
Perform system software upgrades
Download any additional fonts to server
Utilise tools mode to adjust machine setting(transfer, registration etc) as required
for particular jobs.
Monitor and adjust calibration for colour matching of colour management
system
Install RIP utilities, printer description files, and print drivers on Client
workstations.
Secure all system software
Setup and administer clients
* Fuji Xerox will provide installation of RIP client software and drivers on one client PC & MAC, as part of the
installation and training session. It is the responsibility of the Customer to disseminate Drivers and utilities to
all other users.
** Fuji Xerox responsibility when a Full Service and Maintenance Agreement (FSMA) is purchased. If FSMA is not
purchased, this action becomes a customer responsibility.
Sleep
2W (or less) 218W (or less)
5.8 BTU/h 743 BTU/h
N/A +- 34.7 dB (A)
Action
Stand-by Running
1.14 KW (or less)
3889 BTU/h
+- 57.4 dB (A)
Customer
Responsibility
Fuji Xerox
✓
✓
✓
✓
✓*
✓
✓
✓
✓
✓
✓**
✓**
✓**
✓**
✓**
✓
✓
✓
✓
✓
✓
8