Table of Contents
Advertisement
Adjusting the
Motion-Control Levers
If the motion-control levers do not align horizontally,
adjust the motion-control levers.
1.
Park the machine on a level surface, disengage
the PTO, and move the motion-control levers
outward to the P
ARK
2.
Shut off the machine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Turn the battery-disconnect switch to the O
position.
4.
Push the motion-control levers down out of the
P
position.
ARK
Figure 67
1. Left motion-control lever
2. Right motion-control lever
in the P
position
ARK
5.
Check the horizontal alignment of both levers by
using the front or rear reference bar as a guide.
Note:
If a lever is not aligned, proceed to step
to adjust the cam for that lever.
6.
Release the cushion from the rear of the
machine and remove the rear access cover.
7.
Loosen the bolt holding the cam.
position.
FF
3. Check the horizontal
alignment here
4. Right motion-control lever
1. Cam
8.
Adjust the cam until it aligns with the front or rear
reference bar and tighten the bolt for the cam.
Note:
Moving the cam clockwise lowers the
handle; moving the cam counterclockwise raises
the handle.
g376309
Important:
cam does not go above a vertical position
(right or left); otherwise you may damage the
switch.
9.
Install the rear access cover and operator
cushion.
6
42
Figure 68
Left cam shown.
2. Bolt
Ensure that the flat portion of the
g377041
Advertisement
Table of Contents
