Table of Contents
Advertisement
Adjusting the
Motion-Control Levers
Adjusting the Height
You can adjust the motion-control levers higher or
lower for maximum comfort
Figure 10
Adjusting the Tilt
You can adjust the motion-control levers forward or
rearward for your comfort.
1.
Loosen the upper bolt holding the control lever
to the control-arm shaft.
2.
Loosen the lower bolt just enough to pivot the
control lever forward or rearward
3.
Tighten both bolts to secure the control lever in
the new position.
4.
Repeat the adjustment for the other control lever.
(Figure
10).
g027252
(Figure
10).
Converting to Side
Discharge
Machines with 81 cm (32-inch)
Mower Decks
The mower deck and mower blades shipped with the
machine were designed for optimum mulching and
side-discharge performance.
Removing the Discharge Cover for Side
Discharging
1.
Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Remove the wing nut and bolt securing the
cover in place
Note:
Retain all of the parts for future use.
1. Grass deflector
2. Discharge cover
3. Lower lip
4.
Remove the hinge pin securing the cover to the
deck
(Figure
11).
5.
Lift the cover out and away from the deck.
6.
Lower the grass deflector over the discharge
opening.
Important:
Ensure that the mower has
a hinged grass deflector that disperses
clippings to the side and down toward the
turf while in side-discharge mode.
16
(Figure
11).
Figure 11
4. Hinge pin
5. Wing nut
g004582
Advertisement
Table of Contents
