Adjusting the Height-of-Cut
The height-of-cut can be adjusted from 38 to 127 mm
(1-1/2 to 5 inches) in 6 mm (1/4 inch) increments.
Figure 29
Adjusting the Anti-Scalp
Rollers
Models with a 152 cm (60 Inch)
Deck Only
Whenever you change the height-of-cut, adjust the
height of the anti-scalp rollers.
1.
Disengage the blade-control switch (PTO), move
the motion-control levers to the N
position, and engage the parking brake.
2.
Shut off the machine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Remove the nut and bolt position the anti-scalp
rollers and install the nut and bolt.
4.
Ensure that the spacers and bushings are
installed.
1. Bushing
2. Anti-scalp roller
3. Spacer
Adjusting the Rake of the
Mower Deck
Adjusting the rake of the mower deck may improve
the machine run time. You can raise the rear of the
mower deck in 6.3 mm (1/4 inch) increments, up to
31.8 mm (1-1/2 inch).
g330789
1.
Disengage the PTO and move the motion-control
levers outward to the P
2.
Shut off the machine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Raise the height-of-cut lever and lock it into the
transport position.
4.
On the left or right side of the machine, raise the
lever and remove the pin.
23
EUTRAL
Figure 30
4. Bolt
5. Nut
position.
ARK
-
LOCK
g407636