Table of Contents
Advertisement
4.
Insert a ratchet with a 3/8 inch drive into
the square hole in the motor hub. Rotate it
counterclockwise until it stops (approximately
4 full rotations) to disengage the transmission.
Torque to 41 to 68 N∙m (30 to 50 ft-lb).
Note:
The wheel will spin freely.
Figure 36
5.
Repeat for the other motor.
6.
Move the machine to the desired location.
Important:
Do not move the machine faster
than 8 km/h (5 mph).
7.
Immediately after moving the machine, engage
the transmission for operation.
A.
Insert a ratchet with a 3/8 inch drive into the
square hole in the motor hub.
B.
Rotate it clockwise until it stops
(approximately 4 full rotations).
C.
Torque to 41 to 68 N∙m (30 to 50 ft-lb).
Figure 37
Transporting the Machine
Use a heavy-duty trailer or truck to transport the
machine. Use a full-width ramp. Ensure that the trailer
or truck has all the necessary brakes, lighting, and
marking as required by law. Please carefully read all
the safety instructions. Knowing this information could
help you or bystanders avoid injury. Refer to your
local ordinances for trailer and tie-down requirements.
WARNING
Driving on the street or roadway without
turn signals, lights, reflective markings, or a
slow-moving-vehicle emblem is dangerous
and can lead to accidents, causing personal
injury.
Do not drive the machine on a public street
or roadway.
g398425
WARNING
Loading a machine onto a trailer or truck
increases the possibility of backward tip-over
and could cause serious injury or death.
• Use only full-width ramps; do not use
individual ramps for each side of the
machine.
• Ensure that the length of ramp is at least 4
times as long as the height of the trailer or
truck bed to the ground.
• Use extreme caution when operating a
machine on a ramp.
• Back the machine up the ramp and walk it
forward down the ramp.
• Avoid sudden acceleration or deceleration
while driving the machine on a ramp as
this could cause a loss of control or a
tip-over situation.
g398426
27
Advertisement
Table of Contents
