Repositioning The Cooker Following Connection; Levelling - Rangemaster Elan 110 Induction G5 User's Manual & Installation Instructions

Table of Contents

Advertisement

Lowering the Two Rear Rollers
To adjust the height of the rear of the cooker, rst t a 13 mm
spanner or socket wrench onto the hexagonal adjusting
nut (Fig.8-5). Rotate the nut – clockwise to raise – counter-
clockwise to lower.
Make 10 complete (360°) turns clockwise.
Make sure you lower BOTH REAR ROLLERS.
Completing the Move
Unfold the rear edge of the pack base tray. Open the grill
door and right-hand oven door so that you can get a good
grip on the bottom of the fascia panel as you move the oven
(Fig.8-6).
Carefully push the cooker backwards o the pack base.
Remove the pack base tray.
Position the cooker close to its nal position, leaving just
enough space to get behind it (Fig.8-7).
DO NOT use the door handles or control knobs to
n
n
manoeuvre the cooker.
Repositioning the Cooker Following
Connection
If you need to move the cooker once it has been connected
then you need to unplug it and, having gripped under the
fascia panel and lifted the front of the cooker slightly
(Fig.8-6).
As you progress, make sure that the electricity cable always
has su cient slack to allow the cooker to move.
When you replace the cooker, again check behind to make
sure that the electricity cable is not caught or trapped.

Levelling

You are recommended to use a spirit level on a shelf in one of
the ovens to check for level.
Place the cooker in its intended position taking care not to
twist it within the gap between the kitchen units as damage
may occur to the cooker or the units.
The front feet and rear rollers can be adjusted to level the
cooker. To adjust the height of the rear of the cooker, turn the
adjusting nuts at the front bottom corners of the cooker.
To adjust the height of the rear of the cooker, use a 13 mm
spanner or socket wrench to turn the adjusting nuts at the
front bottom corners of the cooker. To set the front feet turn
the bases to raise or lower.
Check the appliance is electrically safe when you have nished.
INSTALLATION
27
ArtNo.010-0004 Moving the cooker
Fig.8-5
Fig.8-6
Fig.8-7

Advertisement

Table of Contents
loading

This manual is also suitable for:

Professional deluxe 110 induction g5

Table of Contents