Table of Contents
Advertisement
English
Fig.7-1
ArtNo.324-0005 Oven light bulb
Fig.7-2
ArtNo.324-0007 Unscrewing the bulb cover
Fig.7-3
ArtNo.320-0006 Oven door hinge adjustment 1
E ect of hinge adjustment – exagerrated for clarity
Fig.7-4
Centreline of hinge pin
ArtNo.320-0007 Oven door hinge adjustment 2
Oven door omitted for clarity
Food is cooking too slowly, too quickly, or burning
Cooking times may di er from your previous
oven. Check that you are using the recommended
temperatures and shelf positions – see the oven
cooking guide. You can then adjust the settings
according to your own individual tastes.
Oven temperature getting hotter as the cooker gets older
If turning the temperature down using the oven control
knob has not worked, or has only worked for a short
time, then you may need a new thermostat. This should
be tted by a service person.
The oven is not cooking evenly
Do not use a baking tray with dimensions larger than
those speci ed in the section on 'General Oven Tips' .
If you are cooking a large item, be prepared to turn it
round during cooking.
If two shelves are used, check that space has been left
for the heat to circulate. When a baking tray is put into
the oven, make sure that it is placed centrally on the
shelf.
Check that the door seal is not damaged and that the
door catch is adjusted so that the door is held rmly
against the seal.
A dish of water when placed on the shelf should be the
same depth all over. (For example, if it is deeper at the
back, then the back of the cooker should be raised up or
the front lowered.) If the cooker is not level, arrange for
your supplier to level it for you.
The Oven light is not working
The bulb has probably burnt out. You can buy a
replacement bulb (which is not covered under the
guarantee) from a good electrical shop. Ask for a 15 W –
230 V lamp, FOR OVENS. It must be a special bulb, heat
resistant to 300 °C (Fig.7-1).
Before removing the existing bulb, turn o the power
supply and make sure that the oven is cool. Open the
oven door and remove the oven shelves.
Locate the bulb cover and unscrew it by turning it
counter-clockwise (it may be very sti ) (Fig.7-2).
Now unscrew the existing bulb counter-clockwise,
taking care to protect your ngers with a glove in case
the bulb should shatter.
Screw in the new bulb clockwise and then screw the
bulb cover back on. Turn on the electricity supply and
check that the bulb now lights.
The oven door is misaligned
The bottom hinge of either oven door can be adjusted
to alter the angle of the door (Fig.7-3). Loosen the
bottom hinge xing screws and use the notch and a at
bladed screwdriver to move the position of the hinge to
set the hinge position (Fig.7-4).
Retighten the hinge screws.
24
Advertisement
Table of Contents
