Supermicro X11DPH-I User Manual page 98

Super X11DPH-i/X11DPH-T/X11DPH-Tq User's Manual
boot the computer using a legacy device installed on the PCI-E slot specifi ed by the user. The
options are Disabled, Legacy and EFI. (Note: Riser card names may differ in each system.)
Bus Master Enable
If this setting is set to Enabled, the PCI Bus Driver will enable the Bus Master Attribute for
DMA transactions. If this setting is set to Disabled, the PCI Bus Driver will disable the Bus
Master Attribute for Pre-Boot DMA protection. The options are Disabled and Enabled.
Onboard LAN Device
Select Enable to use onboard LAN devices. The options are Disabled, Enabled, and Auto.
Onboard LAN1 Option ROM
Use this feature to select the type of device installed in LAN Port1, which will be used for
system boot. The options are Legacy, EFI and Disabled.
Onboard LAN2 Option ROM
Use this feature to select the type of device installed in LAN Port2, which will be used for
system boot. The options are Legacy, EFI and Disabled.
Onboard Video OPROM (Option ROM)
Use this feature to select the Onboard Video Option ROM type. The options are Disabled,
Legacy and UEFI.
 Network Stack Confi guration
Network Stack
Select Enabled to enable PXE (Preboot Execution Environment) or UEFI (Unifi ed Extensible
Firmware Interface) for network stack support. The options are Enabled and Disabled.
*If "Network Stack" is set to Enabled, the following items will display:
IPv4 PXE Support
Select Enabled to enable IPv4 PXE boot support. If this feature is disabled, it will not create
the IPv4 PXE boot option. The options are Disabled and Enabled.
IPv4 HTTP Support
Select Enabled to enable IPv4 HTTP boot support. If this feature is disabled, it will not create
the IPv4 HTTP boot option. The options are Enabled and Disabled.
IPv6 PXE Support
Select Enabled to enable IPv4 PXE boot support. If this feature is disabled, it will not create
the IPv4 PXE boot option. The options are Disabled and Enabled.
IPv6 HTTP Support
Select Enabled to enable IPv4 HTTP boot support. If this feature is disabled, it will not create
the IPv4 HTTP boot option. The options are Enabled and Disabled.
98