Supermicro X11DPH-I User Manual page 12

Super X11DPH-i/X11DPH-T/X11DPH-Tq User's Manual
Quick Reference Table
Jumper Description
JBT1 CMOS Clear
JPME2 ME Manufacturing Mode
JWD1 Watch Dog Timer Enable
Connector Description
BT1 Onboard CMOS battery
COM1 COM port on the I/O back panel
FAN1-6, FANA/FANB System/cooling fan headers
IPMI_LAN Dedicated IPMI LAN port
I-SATA0~3, I-SATA4~7 SATA 3.0 Ports supported by the Intel PCH
JD1 Speaker/buzzer header (use in conjunction with an external speaker/buzzer) (optional)
JF1 Front control panel header
JHSSI High-Speed Serial Interface (HSSI) card header
JIPMB1 4-pin External I
Chassis intrusion header (For this feature to work properly, please connect an optional external
JL1
speaker to the onboard speaker header at JD1.)
JNCSI Network Controller Sideband Interface (NCSI) header
JPI C1 Power I
2
JPWR1, JPWR2, JPWR4 8-pin power supply connectors
JPWR3 24-pin ATX main power supply connector
JRK1 Intel RAID key for NVMe SSD (Solid State Devices)
JSD1, JSD2 SATA DOM (Device-on-Module) power connectors
JSDCARD1 Micro SD card slot
JSTBY1 Standby power header
JTPM1 Trusted Platform Module (TPM)/Port 80 connector
JUIDB1 Unit Identifi er (UID) switch
LAN1, LAN2 10GbE LAN ports (for the X11DPH-T(q)) and Gigabit LAN ports (for the X11DPH-i)
M.2-C1, M.2-C2 PCI-E M.2 slots (w/VMD support) (See the notes below.)
MH4, MH11 M.2 mounting holes
(CPU1) SLOT1, SLOT3,
PCI-Express 3.0 x8 Slots supported by CPU1 (See the notes below.)
SLOT6, SLOT7
(CPU2) SLOT2, SLOT4,
PCI-Express 3.0 x16 Slot supported by CPU2 (See the notes below.)
SLOT5
S-SATA0, S-SATA1 Powered SATA 3.0 ports with support of Supermicro SuperDOM (Disk-On-Module)
Note 1: Intel VMD is supported by PCI-E Slot 1 - Slot 7, M.2-C1 ,and M.2-C2 slots. 2:
After you've enabled VMD in the BIOS on a PCI-E slot of your choice, this PCI-E slot
will be dedicated for VMD use only, and it will no longer support any PCI-E device.
To re-activate this slot for PCI-E use, please disable VMD in the BIOS. 3: To avoid
interference with other components, please be sure to use an add-on card that is fully
compliant with the PCI Standards on a PCI slot.
C Header (for an IPMI card)
2
C System Management Bus (SMBus) header
2
12
Default Setting
Open (Normal)
Pins 1-2 (Normal)
Pins 1-2 (Reset)