Supermicro X11DPH-I User Manual page 95

SATA RSTe Boot Select (Available when Confi gure SATA as is set to RAID)
Select Enable for full int13h support which will allow the system to boot using a device attached
to the SATA controller. The options are Disable and Enable.
Aggressive Link Power Management
When this feature is set to Enable, the SATA AHCI controller manages the power use of the
SATA link. The controller will put the link in a low power mode during an extended period of
I/O inactivity, and will return the link to an active state when I/O activity resumes. The options
are Enable and Disable.
SATA RAID Option ROM/UEFI Driver (Available when Confi gure SATA as is set to
RAID)
Select EFI to load the EFI driver for system boot. Select Legacy to load a legacy driver for
system boot. The options are Disable, EFI, and Legacy.
SATA Port 0 - SATA Port 7
Hot Plug
Select Enable to support Hot-plugging for the device installed on a selected SATA port
which will allow the user to replace the device installed in the slot without shutting down
the system. The options are Enable and Disable.
Spin Up Device
When this feature is set to Enable, the SATA device installed on the SATA port specifi ed by
the user will start a COMRESET initialization when an edge is detected from 0 to 1. The
options are Enable and Disable.
SATA Device Type
Use this feature to specify if the device installed on the SATA port specifi ed by the user
should be connected to a Solid State drive or a Hard Disk Drive. The options are Hard
Disk Drive and Solid State Drive.
PCH sSATA Confi guration

When this submenu is selected, the AMI BIOS automatically detects the presence of the
sSATA devices that are supported by the sSATA controller and displays the following items:
sSATA Controller
This item enables or disables the onboard sSATA controller supported by the Intel PCH. The
options are Enable and Disable.
Confi gure sSATA as (Available when sSATA Controller is set to Enable)
Select AHCI to confi gure an sSATA drive specifi ed by the user as an AHCI drive. Select RAID
to confi gure an sSATA drive specifi ed by the user as a RAID drive. The options are AHCI
and RAID. (Note: This feature is hidden when the sSATA Controller item is set to Disabled.)
95
Chapter 4: UEFI BIOS