Table of Contents
Advertisement
OPTIONAL VIGNETTE FACEPLATE INSTALLATION
OPTIONAL VIGNETTE FACEPLATE INSTALLATION
1. Install the lower trim to the unit with 2 screws on each side as shown
in the drawing below.
2. Install 3 sided/4 sided vignette faceplate to the unit with 2 screws each
on top and bottom as shown in the picture below..
3 sided Vignette
Faceplate shown
3. Connect the male end black and red fan switch wires (in the silver box)
to the wires connectors from the fan speed control box .
919-575
4. Tuck the wires into the silver box and secure them with a
small grommet.
5. Bend the silver cover to close the box.
6. Install the fan speed control box to the left side of the unit (when
facing the front of the unit) with 2 screws. Refer to the picture
below. .
Tighten these 2 screws
7. Install the safety screen to the unit.
E33-10 FPI Direct Vent Gas Insert
installation
E33-10
Silver cover
Grommet
5/19/15
|
23
|
23
Hide quick links:
Advertisement
Table of Contents
