Advertisement
CLEANING INSTRUCTIONS
Cleaning the 1.0 Gallon or 1.5 Gallon Thermal Dispensers (Daily)
WARNING:
DO NOT immerse the thermal server or its lid assembly in water or any other liquid. Do not place the
thermal server or lid in a dishwasher. Placing a thermal server in a dishwasher will void the warranty.
To avoid damage, DO NOT use a brush to clean the faucet or the inside of the faucet shank (outlet).
Cleaning the Container
1
Prepare a mild solution of detergent and warm
water. Remove the server from the brewer and
remove the lid. Rinse.
Wash - Wipe the exterior surfaces of the container
with a sponge soaked with the detergent solution
the liner with the detergent solution. Take a sponge
brush and scrub out the stainless steel liner and the
lid.
3
Rinse - Rinse with clean, warm water.
4
Sanitize - Sanitize the interior of the server and
the lid, using a commercial sanitizer suitable for
food grade applications. Sanitize according to the
directions on the package.
5
Disassemble the faucet - Unscrew the handle/
bonnet assembly from the top of the faucet and
remove it. Inspect the seat cup for wear. Replace
the seat cup if it is damaged.
Disassemble the sight gauge (some versions). If
the sight gauge has a cover, pull it up and off to
remove. Remove the cap to disassemble the gauge
(both versions). Some versions are equipped with a
guard that must be unscrewed to access the lower
for cracks or chips. If broken, replace the glass with
a new one.
Air Dry - Turn the container and lid upside down
and allow to air dry.
Cleaning the Faucet Parts and Site Gauge
Wash - Wash all faucet and gauge glass parts with
the detergent solution. Using the supplied brush,
of the gauge glass with a gauge brush soaked with
detergent solution.
Rinse - Thoroughly rinse all parts with clean, warm
water.
continued....
TXSG Series
Glass tube
Guard
Handle
Bonnet
Float
Washer
Seat cup
Faucet
Assembly
TLCG Series
Handle
Bonnet
Cover
Seat cup
Faucet
Assembly
CI5
Cap
Washer
Lid
Cap
Glass tube
Lid
Advertisement
