Advertisement
PROGRAMMING GUIDE
Programming Options
Some menus save and exit automatically when a parameter is updated. Other menus exit to the previous menu
when a parameter is saved. To exit, press
Global Recipes Menu
Select from the following coffee types: Gourmet STD (standard), Light Roast, Dark Roast, High Yield, Filter
Pack or Decaf. The factory default setting is Gourmet STD. Selecting the coffee type sets the various brew
settings for the brewer, shown below and on the following pages, to the factory recommended settings for the
type of coffee being brewed. If desired, the individual brew settings may be changed once the coffee type is
selected to meet your brewing needs.
IMPORTANT: If you change any of the brewer settings on the following pages, some or all of them
Non-Brew Programming Menu
Temperature -
to set and exit.
Energy Save Mode - saves energy during periods when the brewer is not in use (the factory default is OFF).
When set to ON, the brewer automatically shuts off four hours (two hours on older units) after the last brew
four hours (two hours on older units) after the last brew cycle. Press the ON/OFF button to return to normal
non-use. Once accessed, press
Brew Count Odom - When accessed, this feature displays the total brew cycles since the odometer was last
reset. Press
to exit or
Quality Timer -
FEATURES section for a complete description of how the timer operates. Once accessed, press
choose the desired setting. Then press
Brew Count Total - when accessed, displays the total brew cycles on the brewer. It cannot be reset. The
display returns to the previous screen automatically after a few seconds.
Cold Brew Lock - adjusts the temperature at which the brewer will brew coffee when the BREW button is
pressed (Ready to Brew
temperature at which the heating element turns on to reheat the water in the tank. The available settings
choose the desired setting. Then press
Master Reset - resets the brewer universal control module (UCM) to the factory default settings. Once
accessed, "Are You Sure?" will appear on the display. Press
IMPORTANT: If you reset the UCM to the factory defaults, you MUST reprogram the Model Select
and number of batches to match the number on the model number label and the label on the UCM for
proper operation.
until EXIT appears on the display, then press
or
to choose the desired setting. Then press
reset and exit.
to set and exit.
to set and exit.
or
to choose the desired temperature. Then press
for Yes or
for No.
PG2
.
to set and exit.
®
INTELLIFRESH
or
to
or
to
Advertisement
