Table of Contents
Advertisement
Expanding and assigning parameters to the device
6.4 Expansion modules (M.2)
3.
4.
If the M.2 module includes a cable with an additional interface card that must be connected
to the enclosure opening, you must also execute the following steps:
5.
6.
7.
70
Insert the M.2 module into the relevant
slot (X100 or X101).
Take care not to touch the contacts of
the M.2 module when you do this.
Fasten the M.2 module with the screw
that you removed in step 2.
Only use the original screws with the
spacers.
Note: Make sure that the M.2 module is
between the head and the spacer of the
screw.
Loosen the marked screws for fixing the
blanking cover using the Torx T10 screw-
driver.
Place the additional interface card from
the inside against the empty enclosure
opening and fasten it using the screw.
Connect the cable of the interface card
to the M.2 module.
Operating Instructions, 08/2022, A5E51699601-AA
SIMATIC IPC PX-39A
Advertisement
Table of Contents
