Table of Contents
Advertisement
Installing and connecting the device
3.3 Connecting the device
Requirement
• The device has been installed.
• You have observed the information under "Country-specific information on supply voltage
(Page 41)".
• Screwdriver T10
Procedure
1. Make sure that the ON/OFF switch is in position "O" (Off) to avoid unintentional startup of
the device when you plug in the power cord.
2. Insert the capacitor IEC plug at the marked position.
3. Connect the power cable with the safety power outlet.
4. If necessary, install the enclosed cable grip.
See also
Connecting the protective conductor (Page 42)
44
Operating Instructions, 08/2022, A5E51699601-AA
SIMATIC IPC PX-39A
Advertisement
Table of Contents
