Omron sysmac NA Series User Manual page 44

2 Basic Ladder Monitor Operations
Additional Information
• Double-tap the function blocks in order to display the contents of the function blocks.
To close the display of the open function block, tap the
the name of the function block.
Protected ones and function blocks that use ST are not supported.
• STs are not supported.
• The contents of inline STs and functions cannot be displayed.
• Only the part of a comment that fits the width of the cell is displayed in the initial state.
Tapping the comment will display the entire comment. Or, you can change to the display
mode that displays comments by aligning the cell width to the comment length by tapping
Menu - Fixed length display mode to clear the check.
• Comment 1 is displayed in the initial state.
You can select the comment to display by tapping Menu - Change Comment.
• In the Ladder Monitor, sometimes, the change in the status of the power flow based on the
operation mode of the controller cannot be correctly reflected. Use RUN mode as the operat-
ing mode.
• Comments are not displayed for system variables.
2 - 10
button in the dialog that displays
NA-series Ladder Monitor User's Manual (V124)