Replacing The Tilt-Only Monitor Stand Base; Removing The Front Cover - Lenovo V130–20IGM AIO User Manual And Hardware Maintenance Manual

Replacing the tilt-only monitor stand base

Attention: Do not open your computer or attempt any repairs before reading the Important Product
Information Guide.
1. Remove any media from the drives and turn off all connected devices and the computer. Disconnect all
power cords from electrical outlets and disconnect all cables from the computer.
2. Place a soft, clean towel or cloth on the desk or surface. Hold the sides of your computer and gently lay
it down so that the screen is against the surface and the computer cover is facing up.
3. Replace the tilt-only monitor stand base.
Figure 12. Removing the tilt-only monitor stand base
Figure 13. Installing the tilt-only monitor stand base

Removing the front cover

Attention: Do not open your computer or attempt any repairs before reading the Important Product
Information Guide.
CAUTION:
.
Chapter 4 Replacing hardware
17