Table of Contents
Advertisement
Power button and fingerprint reader boards
If a fingerprint reader is installed, the power button board and fingerprint reader board are wired together
into one assembly, located at the bottom right of the computer. If the fingerprint reader is not installed, the
power button board can be removed using the steps below.
Healthcare models may include a fingerprint scanner. Standard models may include a swipe fingerprint
reader.
To remove the power button and fingerprint reader boards:
1.
Prepare the computer for disassembly (see
2.
Remove the rear port cover (see
3.
Remove the stand (see
4.
Remove the access panel (see
5.
Remove the Torx screw from the power button board bracket (1), and two Phillips screws from the
fingerprint reader board (2).
6.
Lift the boards from the computer.
30
Chapter 4 Removal and Replacement Procedures
Preparing to disassemble the computer on page
Removing the rear port cover on page
Stands on page
19).
Access panel on page
18).
20).
18).
Advertisement
Table of Contents
