Table of Contents
Advertisement
WLAN module
The WLAN module is located on the system board above the memory modules. The WLAN module is secured
with one Phillips screw and has two connected antennas.
For a list of available WLAN modules, see
NOTE:
The procedure to replace the WLAN module must be performed by an HP technician.
NOTE:
WLAN module appearance may vary.
To remove the WLAN module:
1.
Prepare the computer for disassembly (see
2.
Remove the rear port cover (see
3.
Remove the stand (see
4.
Remove the access panel (see
5.
Disconnect the antenna cables from the module (1).
6.
Remove the Phillips screw (2) that secures the module to the computer.
7.
Lift the module to a 45-degree angle, and then pull it away to remove it from the socket (3).
To install the WLAN module, reverse the removal procedures.
When connecting the antennas cables, connect the cable labeled "1" (black sticker) to the AUX "1" connector
on the module and the cable labeled "2" (white sticker) to the MAIN "2" connector on the module.
NOTE:
WLAN modules are designed with a notch to prevent incorrect insertion.
Boards on page
Preparing to disassemble the computer on page
Removing the rear port cover on page
Stands on page
19).
Access panel on page
8.
18).
20).
18).
WLAN module
29
Advertisement
Table of Contents
