Power Button And Fingerprint Sensor Boards - HP EliteOne G5 Maintenance & Service Manual

Power button and fingerprint sensor boards

NOTE: A fingerprint sensor is available only on select models.
If a fingerprint sensor is installed, the power button board and fingerprint sensor board are wired together
into one assembly, located at the bottom right of the computer. If the fingerprint sensor is not installed, you
can remove the power button board using the following steps but omitting the fingerprint sensor steps.
To remove the power button and fingerprint sensor boards:
1. Prepare the computer for disassembly (see
2. Remove the rear port cover (see
3. Remove the stand (see
4. Remove the access panel (see
5. Remove the Torx screw from the power button board bracket (1), and two Phillips screws from the
fingerprint sensor board (2).
6. Lift the boards from the computer.
Preparation for disassembly on page
Removing the rear port cover on page
Stands on page 24).
Access panel on page
23).
25).
Power button and fingerprint sensor boards
23).
35