Power Button/Card Reader Board - HP 200 G3 Maintenance And Service Manual

Power button/card reader board

1. Prepare the computer for disassembly (see
2. Remove the stand assembly (see
3. Remove the display (see
4. Disconnect the cable from the ZIF connector on the power button/card reader board (1).
5. Remove the two Phillips screws (2), and then lift the board out of the computer (3).
Reverse this procedure to install the power button/card reader board.
Preparation for disassembly on page
Stand assembly on page
Display on page 16).
14).
15).
Power button/card reader board 25