Table of Contents
Advertisement
Position this generator on a hard, flat and leveled surface.
Position this generator 3 ft. (1 m) or more from walls or other hindrances so that the operation
panel door and left/right check doors are accessible for internal inspection/maintenance.
< Note >
This generator is manufactured presupposing that it will be installed on a flat, hard and
leveled surface. Accordingly, care must be taken as using under any other installation
conditions can result in a fault or malfunction.
Do not place any objects where they will interfere with the radiator or muffler exhaust ports.
Objects interfering with these ports will result in reduced engine output, overheating, and
electrical component fault/malfunction.
Operating the equipment in dusty or excessively salty location can result in a clogged
radiator or overheating resulting in malfunction/fault or reduced insulation of electrical
components. Be sure to thoroughly inspect and perform maintenance if using in such
locations.
Check that the surrounding area is safe, before set to auto mode.
Be sure to communicate mutually before attempting to set "AUTO MODE" by multiple
operators to avoid mechanical trouble and incidents.
7. Load Connections
7-1. Load Cable Selection
CAUTION : PROPERTY DAMAGE
Cable burnout could occur due to generated heat if the load current exceeds the
allowable current of the cable.
The voltage drop between cables is large if the cable is excessively long or thin,
resulting in decreased input voltage to equipment using the generator, thereby
causing decreased performance, faulty operation and malfunction.
Select cable for use that has sufficient thickness and an allowable current for use, and
distance from the generator to the equipment using the generator.
< Note >
Select cable with a thickness that ensures that the voltage drop across the cable will be
within 5% of the rated voltage.
Load Cable Selection Tables
(Ex.) If used voltage is 240 V and voltage drops by 12 V.
Length 100 ft (30 m)
Current
or less
50 A
10
100 A
150 A
200 A
250 A
300 A
Three-phase: Cabtyre cables
200 ft.
(61 m)
8
8
4
6
2
4
1
4
1
2
1/0
300 ft.
400 ft.
(91 m)
(122 m)
6
4
2
1
1
1/0
1/0
2/0
2/0
3/0
3/0
4/0
33
(Unit: AWG)
500 ft.
600 ft.
(152 m)
(183 m)
4
2
1
1/0
2/0
3/0
3/0
4/0
4/0
－
－
－
Advertisement
Table of Contents
