Warning Indicators - Shindaiwa DGK180FP Operator's Manual

Diesel engine generator
Table of Contents

Advertisement

5-5. Warning Indicators

WARNING : INJURY
 Do not open the check door when the power switch is turned and the main power is
on. It will cause injury by rotating parts such as cooling fans and fan belt.
 Always press power switch to turn off the main power and stop the engine, then close
and lock OPERATION PANEL DOOR before checking or maintaining the engine or
any equipment.
CAUTION : BURNS
 Do not touch the engine and surrounding components immediately after stopping the
engine as they are still extremely hot.
This generator is equipped with the following warning indicators: BATTERY (battery charge),
OIL PRESS (engine oil pressure), WATER TEMP (coolant temperature), OVER SPEED
(engine overspeed), AIR FILTER (air cleaner clogging), SPILL CONTAINMENT (spill
containment amount), and ENGINE (engine malfunction). When you press the "Start" button to
start the engine, causes the BATTERY warning indicator to illuminates and ENGINE for
warning indicator to illuminates approximately 3 sec. When the engine starts, all the lamps will
be lights off. An indicator illuminates if a malfunction/fault occurs during operation and the
engine automatically stops depending on the fault type.
(1) BATTERY (Battery Charge) Warning Indicator (Low Battery Voltage)
The BATTERY warning indicator illuminates when charging is not possible during operation. If
this occurs, contact authorized distributor where the generator was purchased.
< Note >
 This battery charging warning indicator cannot detect battery deterioration or insufficient
battery fluid. (Refer to section "8-8. Checking the Battery".)
(2) OIL PRESS (Engine Oil Pressure) Warning Indicator (Low Oil Press.)
CAUTION: BURNS
 Always be sure to stop the engine and allow the engine to cool when performing
inspection or maintenance of engine oil. Opening the oil gauge or oil filler cap during
operation will result in hot oil gushing out.
If the engine oil pressure drops below 7 psi (0.48 x100 kPa) during operation, the OIL PRESS
warning indicators illuminates, and the engine will be automatically stopped. If this occurs,
check the engine oil level and add engine oil until it reaches the maximum level.
< Note >
 This oil pressure warning indicator cannot detect oil deterioration. Change the engine oil
periodically. (Refer to section "8-1. Checking Engine Oil".)
22

Advertisement

Table of Contents
loading

Table of Contents