Lenovo ThinkSystem SR635 V3 User Manual page 77

Step 2. Align the rear backplane with the rear hot-swap drive cage and lower it into the rear hot-swap drive
cage.
Figure 26. Rear backplane installation
Step 3. Connect the cables to the backplane. See
cable connectors come with protective dust caps, make sure to remove them before plugging in.
Step 4. Install the air baffle into the rear hot-swap drive cage as shown.
Figure 27. Air baffle installation
a. Align the air baffle edge with the notch on the drive cage.
b. Press the air baffle down and make sure that it is seated in place.
Step 5. Connect the cables to the system board or expansion slots. See
on page 217.
After you finish
1. Reinstall drives or drive fillers into the rear hot-swap drive cage. See
on page 100.
Chapter 6 "Internal cable routing" on page
Chapter 6 "Internal cable routing"
"Install a 2.5-inch hot-swap drive"
.
Chapter 5
217.If the
Hardware replacement procedures
67