Lenovo ThinkSystem SR635 V3 User Manual page 131

Ensure that the module handle (LACM heat sink bracket) is installed when removing or installing the
LACM. Do not touch the radiator fins. Touching the radiator fins might damage the LACM.
Prepare the following screwdrivers to ensure you can install and remove the corresponding screws properly.
Torque screwdriver type list
Torx T20 screwdriver
Watch the procedure
A video of this procedure is available at YouTube:
DrpxDWLMfgtXO4O6BVYTim
Procedure
Step 1. Install the PSU air baffle. See
Step 2. If you have removed the radiator tray, install the radiator tray to the chassis.
a. Place the tray evenly into the chassis and then move it to the right so that the screw hole on
the tray aligns with the hole on the chassis.
b. Tighten the screw.
Step 3. Separate the LACM module from the shipping tray.
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
.
"Install a power supply unit air baffle baffle" on page
Screw Type
Torx T20 screw
.
Chapter 5 Hardware replacement procedures
145.
121