Lenovo ThinkSystem SR635 V3 User Manual page 128

Torque screwdriver type list
Torx T20 screwdriver
Watch the procedure
A video of this procedure is available at YouTube:
DrpxDWLMfgtXO4O6BVYTim
Procedure
Step 1. Remove the top cover. See
Step 2. Remove the backplane and the backplane cables if necessary. See
drive backplane" on page 60
Step 3. Disconnect the pump cable and leak detection cable of the LACM module from the connector on
the system board assembly. See
Notes:
• If you need to disconnect cables from the system board assembly, disengage all latches or
release tabs on cable connectors first. Failing to release the tab before removing the cables will
damage the cable sockets on the system board assembly. Any damage to the cable sockets
might require replacing the system board assembly.
• The connectors on your system board assembly might look different from those in the
illustration, but the removal procedure is the same.
1. Press the release tab to release the connector.
2. Disengage the connector from the cable socket.
Figure 72. Disconnecting cables from the system board assembly
Step 4. Route the leak detection cable out of the cable clips on the leak detection module.
ThinkSystem SR635 V3 User Guide
118
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
.
"Remove the top cover" on page
and "Power/Sideband cable routing" on page
"Liquid assisted cooling module cable routing" on page
Screw Type
Torx T20 screw
212.
"Remove the front 2.5-inch
244.
242.