Specify The Fader Operation Of The Dm1000 - Yamaha DM 1000 Startup Manual

Select the recording VTR. Move the cursor to the REC column and press the
[ENTER] key to select one REC machine from machines A-H. In this example,
machine C is selected.
"Pre-read" is a feature that allows a single VTR to be used as both the playback
machine and the recording machine for editing.
In case of "Pre-read" mode, no recording VTR must be selected. Otherwise the
selected VTR cannot be controlled as playback VTR.

11. Specify the fader operation of the DM1000

When the video editor is used to crossfade or perform other operations on the
DM1000, the DM1000 can move the faders to the actual levels. In other words
when the crossfade begins, the faders will move upward for the channels that are
fading-in, and move downward for the channels that are fading-out, giving you a
visual indication of the actual levels.
However, if appropriate for your system, you can make settings so that the faders
always control the input signal balance (as on mixers made by other
manufacturers) and do not operate as crossfaders. In the DISPLAY ACCESS
section, press the [REMOTE] key repeatedly to access the ESAM1-32 (ESAM
MACHINE ASSIGN CH1-32) page and ESAM33-48 (ESAM MACHINE
ASSIGN CH33-48) page of the REMOTE screen. There you can turn the MOTOR
button Off so that the faders will not move, or On so that the faders will move. For
this example, turn the MOTOR button On so that the faders will move.
12