Yamaha NUAGE FADER Ncs500-FD Operation Manual page 10

[SOLO]
@
Turns Solo or Listen on (lit) and off (dim). If you hold down
one [SOLO] button and press another, Solo or Listen
between the two can be turned on and off. To select Solo
or Listen, press [LISTEN] (page
ROOM section.
When you press [SOLO] while holding down the
appropriate button(s) in the "MODIFIER Section"
(page 21), the function changes as follows.
Modifier button Function
[SHIFT] Turns Solo or Listen on for a number of
successive channels.
[CTRL] Turns Solo or Listen on only of the channel
for which you pressed [SOLO] last.
[ALT] Turns Solo or Listen off for all channels.
[MUTE]
#
Turns Mute on (lit) and off (dim). If you hold down one
[MUTE] button and press another, Mute between the two
can be turned on and off.
When you press [MUTE] while holding down the
appropriate button(s) in the "MODIFIER Section"
(page 21), the function changes as follows.
Modifier button Function
[SHIFT] Turns Mute on for a number of successive
channels.
[ALT] Turns Mute off for all channels.
[Fader]
$
Adjusts the channel level. Each [Fader] is a touch-
sensitive 100 mm motorized fader.
When you operate a [Fader] while holding down the
appropriate button(s) in the "MODIFIER Section"
(page 21), the function changes as follows.
Modifier button Function
[SHIFT] Adjusts the level finely (fine mode).
[CTRL] Sets the nominal level.
When you touch [Fader], the fader in "Mixer" will be
highlighted. Also, you can select the channel by touching
[Fader]. To turn this function on and off, select it from "Ch
Select" (page 23) in NUAGE FADER Setup. When this
function is on and you touch a [Fader] while holding down
the [SHIFT] button in the "MODIFIER Section"
the function changes as follows.
Modifier button Function
[SHIFT] Continuously selects adjacent channels.
18) in the CONTROL
(page 21),
You can turn the motor power of the [Fader] on and off. To
do this, select it from "Motor"
Setup. When the motor power is off, you can change the
[Fader] parameter after the [Fader] parameter value and
the [Fader] position match.
NUAGE FADER Operation Manual
Description of the Device
(page 23) in NUAGE FADER
10