Checking The Brake Linings Of The Rear Brake - KTM F8101S5 Owner's Manual

Warning
Danger of accidents Old brake fluid reduces the braking effect.
–
Make sure that brake fluid for the front and rear brake is changed in accordance with the service
schedule. (Your authorized KTM workshop will be glad to help.)
Note
Environmental hazard Hazardous substances cause environmental damage.
–
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance with
the applicable regulations.
Info
Never use DOT 5 brake fluid. It is silicone-based and purple in color. Oil seals and brake lines are not
designed for DOT 5 brake fluid.
Avoid contact between brake fluid and painted parts. Brake fluid attacks paint.
Only use clean brake fluid from a sealed container.
12.12

Checking the brake linings of the rear brake

Warning
Danger of accidents Worn-out brake linings reduce the braking effect.
–
Ensure that worn-out brake linings are replaced immediately. (Your authorized KTM workshop will be
glad to help.)
Preparatory work
–
Check the brake linings of the rear brake. (
Main work
–
Stand the vehicle upright.
–
Remove screw cap
–
Add brake fluid to level
Brake fluid DOT 4 / DOT 5.1 (
–
Mount and tighten the screw cap with the membrane and O-
ring.
F01546-10
Info
Clean up overflowed or spilled brake fluid immediately
with water.
–
Check the brake linings for minimum thickness
Minimum thickness
» If the minimum thickness is less than specified:
–
Change the rear brake linings.
–
Check the brake linings for damage and cracking.
» If damage or wear is encountered:
–
Change the rear brake linings.
M01180-10
BRAKE SYSTEM 12
p. 91)
1 2
with membrane and the O-ring.
A
.
p. 138)
≥ 1 mm (≥ 0.04 in)
A
( p. 92)
( p. 92)
A
.
91