KTM F8101S5 Owner's Manual page 79

–
Check the chain sliding guard for wear.
» If the lower edge of the chain pins is in line with, or below,
the chain sliding guard:
–
Change the chain sliding guard.
–
Check that the chain sliding guard is firmly seated.
» If the chain sliding guard is loose:
–
Tighten the screws on the chain sliding guard.
Guideline
Screw, chain
sliding guard
S01249-01
–
Check the chain sliding piece for wear.
» If the lower edge of the chain pins is in line with or below
the chain sliding piece:
–
Change the chain sliding piece.
–
Check that the chain sliding piece is firmly seated.
» If the chain sliding piece is loose:
–
Tighten the screw on the chain sliding piece.
Guideline
Screw, chain slid-
ing piece
S01250-01
–
Check the chain guide with a slide gauge for dimension
Minimum thickness
the chain guide
» If the measured value is less than the specification:
–
Change the chain guide.
402421-10
SERVICE WORK ON THE CHASSIS 11
M6 6 Nm (4.4 lbf ft)
M8
6 mm (0.24 in)
C
of
Loctite ® 243™
15 Nm
(11.1 lbf ft)
C
.
77