Adjusting The Riding Sag - KTM F8101S5 Owner's Manual

10 TUNING THE CHASSIS
10.11
44
402659-10

Adjusting the riding sag

B00292-10
Main work
–
1
Loosen screw .
–
2
Turn adjusting ring until the spring is no longer under ten-
sion.
Holding wrench (90129051000)
–
Measure the overall spring length while the spring is not under
tension.
–
Tighten the spring by turning adjusting ring
A
ment .
Guideline
Spring preload (SX‑F EU)
Spring preload (SX‑F US)
Spring preload (XC‑F US)
Info
Depending on the static sag and/or the riding sag, it
may be necessary to increase or decrease the spring
preload.
–
1
Tighten screw .
Guideline
Screw, shock
absorber adjusting
ring
Finishing work
–
Install the shock absorber.
–
Check the free travel of the foot brake lever. (
–
Remove the motorcycle from the lift stand. (
Preparatory work
–
Raise the motorcycle with a lift stand. (
–
Remove the shock absorber.
–
After removing the shock absorber, clean it thoroughly.
Main work
–
Choose and mount a suitable spring.
2
to measure-
8 mm (0.31 in)
9 mm (0.35 in)
6 mm (0.24 in)
M5 5 Nm (3.7 lbf ft)
( p. 61)
p. 88)
p. 50)
p. 50)
( p. 60)