Water Care Programming - Jacuzzi J-435 Owner's Manual

J-445/J-435 Export
12.7

Water Care Programming

Water care is crucial to maintaining a healthy and clean spa. The
CLEARRAY water purification system leads the way by sanitizing the
water using a UV light bulb. Your spa can be programmed to remind you
when to check and replace certain components.
From the Settings Menu, tap
tab in Orange, Figures 12.7a and 12.7b. Tap
menu. Then select one of the features.
Figure 12.7a
A. Programming the CLEARRAY UV Bulb Timer
The CLEARRAY UV bulb has a life expectancy of 1 year. A timer
activates when power is applied and begins a countdown starting at
365 days. Once the timer expires, an error message will appear of the
display, the UV bulb must be replaced and the timer needs to be reset.
Tap
CLEARRAY 65
Note: The days are stored in memory if the power is interrupted.
1. From the "Water Care" Menu you can to set
the CLEARRAY UV bulb timer, Figure 12.7c.
2. Tap or
increments. The range is from OFF to 365
days. The CLEARRAY UV timer counts down
by days not usage.
Note: It is not recommended that this feature
be turned OFF. In order to continually have the
CLEARRAY system effectively preform its function, it
should be program as instructed.
3. Tap to confirm and save your changes.
4. Tap to return to the "Water Care" Menu. Tap again to return to the
Settings Menu.
5. When the timer expires, a message will appear on the control panel
display, page 65. The CLEARRAY UV bulb must be replaced
(page 60) and the timer must be reset. Tap "reset" and follow the
instructions above to reset the timer. If you tap "snooze" the message
will clear but the error icon
will reappear in 10 days.
42
or
SETTINGS
Heat & Filter
Water Care
Wi-Fi
(Figure 12.7b) to enter the Programming Menu.
to change the days in 10-day
to highlight the "Water Care" menu
Water Care
Water Care
CLEARRAY
Water Refresh
ProClarity
ProClarity Depth 50
Figure 12.7b
will display and the reminder screen
to the enter the
65
60
60
CLEARRAY
65 days left
add
65
days
Figure 12.7c