Jacuzzi J-135 Owner's Manual page 19

9. To gain access to the spa's power terminal block, remove the screws
securing the synthetic cabinet panel under the control panel (Figure
A). Then remove the control box door screws and door (Figure B).
10. Select the power supply inlet you want to use (Figure A). Feed power
cable to control box, then install it through the large opening provided
in the bottom side of the box.
11. Connect wires, color to color, on terminal blocks TB1 and TB3
(Figure C, page 16). TIGHTEN SECURELY! All wires must be
hooked up securely or damage could result.
12. Install control box door and screws and reinstall the cabinet side
panels.
2
5
Note: Equipment location (such as pumps, drain, heater etc.) varies by model.
1. Control Box
2. Power Supply Inlet(s)
3. 2-Speed Pump
4. Heater
Figure A
Equipment Area
7
1
4
6
5. Pump Drain Plug
6. 1-Speed Pump
7. Control Panel
8. Drain
8
3
5
J-100
2
15