Consumer Fault Code Mode Entry; Service Mode Entry - Haier GE GFW510SCN0 Technical Service Manual

Consumer Fault Code Mode Entry

• From an idle state only (all LED's off), press and hold Start pad for 10 seconds.
• After holding Start pad for 10 seconds, all LED's will turn on, signifying user may release Start pad.
Behaviors While In Consumer Fault Code Mode Entry
• The Pause and Door Lock LED's should be constantly blinking while in CFCM.
• The first fault, if present, will show on the display.
• Pressing the Start pad will display the next fault code.
• Fault code will blink on the Seven Segment Display (SSD).
• At the end of the fault list, or if no faults present:
• Seven Segment Display (SSD) will blink "—".
Exiting Consumer Fault Code Mode Entry
• Pressing any pad (other than Start) or turning any knob will exit Consumer Fault Code Mode.
• Consumer Fault Code Mode will time out after 10 minutes.

Service Mode Entry

Press and hold Start pad while rotating cycle selection knob 180 degrees, then release Start pad.
• Once service mode is entered, all LED's will be flashing.
• The cycle selection Knob is now used to control the test selection menu.
• Rotating the knob clockwise (CW) will increment the test numbers in the display.
• Rotating the knob counter-clockwise (CCW) will decrement the test number in the display.
• Once test number is selected, pressing Start will begin the selected test.
Exit Field Service Mode
• Field service mode will time out after 30 minutes if there is no user activity.
• Press and hold (3 second) Start pad.
• Press Power pad.
– 68 –