Table of Contents
Advertisement
To select ULTRAFRESH VENT at any other point, power on the washer, ensure
a cycle is not actively running, and remove any garments from the basket, then
press and release the ULTRAFRESH VENT pad so that the notification tune
plays and the ULTRAFRESH VENT pad LED begins to blink. Then press the
ULTRAFRESH VENT pad again to start the feature.
During the operation of ULTRAFRESH VENT, the door will remain locked and the washer will
intermittently spin at low speeds for up to 8 hours.
If garments are detected in the basket during ULTRAFRESH VENT, the washer will instead run
TUMBLE CARE or 1 STEP WASH + DRY, based on option availability for the model.
The ULTRAFRESH VENT feature may be cancelled at any time by pressing the POWER pad,
turning the cycle knob, or pressing the ULTRAFRESH VENT pad.
*Microban® is a registered trademark of Microban International, Ltd.
1 STEP WASH + DRY (on some models): This option is available on all cycles except Self
Clean. The 1 STEP WASH + DRY is intended for small loads only. Use when clothes need
to be washed, dried and ready to wear or finished the next morning. This feature will tumble
clothes and introduce a constant stream of air into the washer compartment upon completion of
select wash cycles. Although the drying portion is set to 8 hours, the clothes can be removed at
any time by pressing Pause or Power to cancel the cycle.
Tumble Care (on some models): Freshly tumbles garments periodically for up to 8 hours after
the wash cycle is complete to lessen the setting of wrinkles and creases when the user is not
able to move clothing to the dryer right away. At the end of the cycle, the display will scroll
"END" and after ten minutes the Tumble Care will begin. It can be stopped at any time by
pressing the Power pad.
PreWash (on some models): Prewash is an extra wash before the main wash. Use it for
heavily soiled clothes or for clothes with a care label that recommends prewashing before
washing. Be sure to add liquid or powder high-efficiency detergent, or the proper wash
additive to the prewash dispenser. Washers equipped with SmartDispense will automatically
add the proper amount of detergent for prewash based on the load size. PreWash must be
selected prior to pressing Start. The PreWash feature will fill the washer (adding the prewash
detergent), tumble the clothes, drain and spin. Then the washer will run the selected wash
cycle.
NOTE: In some special cycles, the prewash is selected automatically as the default. This
selection can be modified at any time.
AutoSoak (on some models): For soaking garments prior to the wash cycle. This option
begins with a brief tumble and then proceeds to soak the clothes with water and detergent for
a specified period of time. Once complete, the cycle will continue automatically. AutoSoak
must be selected prior to pressing the start pad. The AutoSoak time will add an additional 15
minutes, 30 minutes, 1 hour or 2 hours to the overall wash time. High-efficiency detergent from
the main wash compartment in the dispenser is used for the AutoSoak period and main wash
cycle.
Extra Rinse
This option allows for an extra rinse during a cycle to remove excess dirt and detergent from
soiled loads. Press the Extra Rinse pad to select.
NOTE: On Rinse & Spin cycle, a drain and spin cycle can be achieved by pressing the Extra
Rinse pad until the LED is no longer illuminated.
(Continued next page)
– 17 –
Hide quick links:
Advertisement
Table of Contents
