Heater Assembly (650 And 850 Models) - Haier GE GFW510SCN0 Technical Service Manual

8. With the spring of the wire clamp at the
bottom of the tub gasket (boot), insert the wire
clamp into the lip of the gasket.
9. Using pliers, pull the spring of the wire clamp,
stretching it so the rest of the wire clamp can
be inserted into the lip of the gasket.
10. Again, ensure the gasket is still seated
flat against the front panel. If not, make
necessary adjustments.
11. Reinstall the tub LED light, door glass spray
nozzle, damper and dispenser fill hose nozzle
into the gasket.

Heater Assembly (650 and 850 Models)

• The heater operates only when Sanitize or
Tub Wash is selected.
• The control does not pause to allow the
heater to heat the wash water to the sanitize
temperature.
Heater Algorithm
Start Washing
Wash Time > 3 Min
The heater assembly is to the front half of the
outer tub. It is accessed from the front of the
washer with the front panel removed.
– 48 –
Heater On
Yes
Target
No
Temperature
Reached
Yes
Heater Off
END
(Continued next page)