Overnight Dry Fan - Haier GE GFW510SCN0 Technical Service Manual

Overnight Dry Fan

The overnight dry fan is used for the 1-step wash
and dry of small loads. This cycle is the only
cycle when the fan is used. It is not used for the
UltraFresh or Tumble Care cycles.
Fan Diagnosing
Check the overnight dry fan from the main board
J512 connector pin 1 to pin 4. Should read
approximately 26.5 ohms and is rated 120 VAC.
Main Board
Overnight Dry Fan Removal
1. Remove the control panel and top panel (see
Control Panel and Top Panel in this section).
2. Remove the overnight dry hose from the fan
housing by pulling up on the hose clip lip.
J512
– 43 –
3. Disconnect the fan harness connector.
4. Remove the two screws securing the fan
housing to the cabinet. The screws are
located on the rear of the washer cabinet.
5. Remove fan from the fan housing. When
reinstalling the fan into the housing, ensure
the tag on the fan is facing out toward where
the hose connects to the housing.
(Continued next page)