Haier GE GFW510SCN0 Technical Service Manual page 58

Reed Switch
The bleach cup will always and automatically
flush with water near the end of every wash cycle
before going into rinse. There is not a consumer
selectable function.
Dispenser Assembly Removal
1. Remove the top panel and control panel (see
Top Cover and Control Panel in the Cabinet
and Structure section of this service guide).
2. Squeeze the large hose clamp and slide it
down onto the tub fill hose.
3. Remove the tub fill hose from the dispenser
box.
Squeeze
Clamp
Push Hose
Downward
4. Remove the inlet and the dispenser vent
hoses from the dispenser:
a. Squeeze each clamp and slide it back.
b. If necessary, carefully break each hose
loose by inserting a small flat-blade screw-
driver under the hose to break the seal.
c. Remove the hoses.
d. Disconnect the reed switch harness
connector.
5. Slide box toward the rear to disengage tab
from the side rail.
– 58 –
Reed Switch
Connector
Tab